CyberData 011097 Specifications download pdf (Page 22)

Installing the VoIP V2 Loudspeaker Amplifier

Loudspeaker Amplifier Setup

Operations Guide 930362E CyberData Corporation

2.2.7 Confirm the IP Address and Test the Audio

2.2.7.1 RTFM Switch

When the Loudspeaker Amplifier is operational and linked to the network, use the Reset Test

Function Management (RTFM) switch (

Figure 2-16) on the Loudspeaker Amplifier face to announce

and confirm the Loudspeaker Amplifier’s IP Address and test the audio to verify that it is working.

Figure 2-16. RTFM Switch

Announcing the IP

Address

To announce a Loudspeaker Amplifier’s current IP address:

● Press and hold the RTFM switch for a couple of seconds and then release it.

Restoring the

Factory Default

Settings

To restore the factory default settings, complete the following steps:

1. Press and hold the RTFM switch until you hear the Paging Amplifier announce the words,

“restoring defaults” and “rebooting”.

2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.

2.2.8 Adjust the Volume

There are two ways to adjust the volume for the Loudspeaker Amplifier:

•The Speaker Volume (0-9) setting on the Device Configuration page

•The external Volume dial on the Loudspeaker Amplifier face

RTFM switch

Caution

Equipment Caution: Pressing and holding the RTFM switch for more than five

seconds will restore the V2 Paging Amplifier to the factory default settings. See

the “

Restoring the Factory Default Settings” section.

GENERAL ALERT

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 72 73

No comments

CyberData 011097 Specifications Page 22