CyberData 010935 Specifications download pdf (Page 24)

Installing the VoIP Intercom

Parts List

Operations Guide 930242G CyberData Corporation

2.2.6 RTFM Switch Jumper

When the Intercom is operational and linked to the network, use the Reset Test Function

Management (RTFM) switch (see

Figure 2-15) on the Intercom board to announce and confirm the

Intercom’s IP Address, test that the audio is working, and check the volume.

Note You must do this test prior to final assembly. Please remember to remove the RTFM switch

jumper prior to final assembly.

Figure 2-15. RTFM Switch Jumper

2.2.6.1 Announcing the IP Address

To announce an Intercom’s current IP address:

1. Unplug the Intercom.

2. Install the RTFM jumper on JP11.

3. Plug the network cable into the Intercom to supply power to the Intercom. The LED will

illuminate during initialization, blink once, and then turn off.

4. The Intercom will announce the IP address.

5. After the Intercom has rebooted, remove the jumper from JP11.

6. Cycle power by disconnecting the PoE cable from J1 and plugging the PoE cable back into J1.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

No comments

CyberData 010935 Specifications Page 24